1. Starting the Device
Connect the device to a power source.
2. Entering the Menu
Press the hamburger menu icon (three lines) on the right side.
3. Personalize
Open the Personalize submenu and apply the following settings:
3.1 User Interface
Open User Interface
Set:
Main Screen Style → Style 2
3.2 Voice
Open Voice
Optional:
Turn off device sounds
3.3 Punch State Options
Open Punch State Options
Set:
Punch State Mode according to your needs:
Mode | Description |
Manual Mode | User manually selects start and end of working time |
Auto Mode | Device automatically detects start/end (If working time is started then device sends out END request.) |
Manual and Auto Mode | If a session is already active and “start” is pressed, the previous one ends and a new one begins |
Manual Fixed Mode | Not used |
Fixed Mode | Only “start” or “end” can be selected |
⚠️ Note!
Punch State Required must be ON
4. User Role
Open the User Role submenu:
Define User Role
Set what a regular user (not SUPERADMIN) can see and modify:
User Management
All users
Comm
Ethernet
WiFi settings
Cloud server settings
System
Attendance
Personalize
User interface
Voice
Punch state options
Access Control
Time schedule
Access control options
Work Code
New work code
All work codes
Work code options
System Info
Device capacity
Device info
Firmware
5. Comm (Connections)
Open the Comm submenu and configure the following:
5.1 Ethernet
Enable:
DHCP
5.2 WiFi Settings
Connect the device to a WiFi network
(if not using a cable)
5.3 Cloud Server Settings
Enable:
Enable Domain Name
Enter:
Server Address → device.wemply.com
6. System
Open the System submenu:
Device Type Settings
Make sure:
Protocol → PUSH
Type → T&A